Ingersoll Rand UP6-5TAS 5HP Rotary Screw Air Compressor with Integrated Refrigerated Air Dryer
The Ingersoll Rand UP6-5 TAS is a complete compressed air package. The Total Air System includes a rotary screw compressor, cycling air dryer, and integrated air filtration to remove dust and oil. This is all mounted on an 80 or 120 gallon horizontal air storage receiver. This model will displace 18.5cfm @ 125psi or 16cfm @ 150psi.The Total Air System compressor reduces space, costs less to install, and delivers high quality compressed air.
Ingersoll Rand designed the UP6-5 package enclosure to reduce sound while allowing for easy access to parts and maintenance. The front door lifts off if required to provide easy access to all routine maintenance points. You can remove the side panel for easy access to the dryer and filter section.
A pre-filter is located on the side of the compressor cabinet. This filters the air prior to entering the air compressor. In addition to lengthening the life of the main air filter, it keeps dust and debris away from major components.
A cycling refrigerated air dryer is pre-installed and removes 99.9% of all moisture from the compressed air. As an energy saving feature, the refrigerated air dryer cycles on and off with the compressor. This uses a special stainless steel heat exchanger to pre-cool the air when it enters the dryer and warm the air upon exit.
The integrated dryer uses eco friendly R-134a refrigerant. The micro channel condenser and thermal control includes a quick acting hot gas bypass. The high efficiency cyclone separator removes then removes condensed water after the evaporator. The automatic drain discharges all condensate from a single port on the back of the compressor.
Ingersoll Rand designed the speed, torque and operating characteristics to perfectly match the load of the compressor. IR also optimized the motor efficiency and power factor for the UP6-5 TAS compressor. The motor has a class F insulation and can operate in ambient conditions up to 104 degrees.
The UP6-5 Ingersoll Rand rotary has been one of the most common rotary screw air compressors sold over the past decade. For good measure - the reliability, easy parts access and simple operation will set your facility up for success.
The air compressor operates on 208, 230 or 460 volt power. The default maximum pressure setting is 125psi. The UP6-5 is also available in 100psi or 150psi variants. Voltage and pressure are preset at the factory prior to ordering.
The UP6-5 TAS is pre-wired from the factory based on your building power. This can either be run on three phase or single phase 230v incoming power.
Features and Benefits - UP6-5TAS 5hp rotary screw compressor
- Fewer connections and smart integration eliminate leaks and pressure drops, ensuring maximum reliability
- Integrated cycling refrigerated air dryer
- Pre-installed dual filtration: A general purpose filter to remove dust and debris and a coalescing filter to remove oil and trace vapors.
- Advanced, high-efficiency combination cooler with roof mount package exhaust enables easy ducting
- Package pre-filter protects all main components and keep the internal cabinet clean.
- Small footprint frees up valuable floor space and reduces installation costs
- Simple diagnostics for ease-of-operation and reduced downtime
- Premium Poly-V belt drive system minimizes belt stretching and increases air output
- Pre filled with a PAG based full synthetic compressor lubricant
Additional Product Information