Graco 25N232, Carbide-Tipped Miller, 6-inch Drum Assembly for GrindLazers

Graco 25N232, Carbide-Tipped Miller, 6-inch Drum Assembly for GrindLazers

Graco offers a variety of carbide cutters for nearly any application. These cutters use high-quality tungsten carbide to ensure a long service life.

6-inch carbide-tipped miller cutter drum assembly for Graco GrindLazer Scarifier Systems. Millers scrape the surface to remove markings, making them a suitable choice for removing paint, epoxy, tape, and thermoplastic.

Used on the following GrindLazers:

• GrindLazer Pro DC89
• GrindLazer Pro DC1013
• GrindLazer HP DC89
• GrindLazer HP DC1013
• GrindLazer HP DC1021

Miller Drum Assembly General Information:

• Cutting action / geometry: Scraping action with small carbide-tipped teeth or full-carbide cast cutters.
• Best used for: Thermoplastic line removal, tape, thick/mil paint. Good all-rounder. 
• Surface Finish: Moderate; can leave small scoring if very aggressive, but predictable.
• Speed and Wear: Moderate cutting speed; wear life good (full-carbide lasts longer than tipped).

Details:
Small Side: 21 Spacers, 1 Cutter Big Side: 21 Spacers, 3 Cutters

Specs:

• Part # 25N232
• 6-inch wide cut
• 24 cutters
• 254 spacers
• 6 rods
• 2 end plates
• Fully Assembled

Genuine Graco